Harley Davidson Ignition Switch Replacement

Harley Davidson Ignition Switch Replacement – Easy Step-by-Step Guide

Welcome to the ultimate guide for replacing your Harley Davidson’s ignition switch! Have you ever tried to start your motorcycle, but nothing happened? It might be time to replace your ignition switch. Don’t worry! We are here to help you do it yourself. Even if you’re only 9 years old, we will explain everything in simple words. Let’s get started!

Step 1: Gather Your Tools

First, we need to find some tools. Here’s a list of what you will need for the job:

A new ignition switch (Make sure it fits your Harley!)

A screwdriver (It’s like a key for screws)
A wrench (It’s a tool to turn bolts and nuts)

Now that we have our tools, we can start the real work!

Step 2: Safety First

Before we touch anything, let’s be safe. Make sure your motorcycle is turned off. Take out the key from the ignition.

Step 3: Locate the Ignition Switch

Your ignition switch is where you put the key to start your motorcycle. For most Harley Davidson models, you’ll find it right on the tank. But sometimes, it can be near the dashboard. If you’re not sure where to look, check the owner’s manual.

Step 4: Remove the Old Ignition Switch

Grab your screwdriver. Carefully remove the screws holding the old switch in place. Pull it out gently. See those wires? Take a picture with a camera or your phone. This way, you will remember how to connect the new switch.

Step 5: Disconnect the Wires

Using your wrench, loosen the nuts that hold the wires onto the switch. Be gentle and do not pull the wires too hard. Remember to place all the small parts in a safe spot so you don’t lose them.

Step 6: Connect the New Ignition Switch

Let’s open the box with the new ignition switch. Look at the picture you took of the old wires. Use it to connect the wires to the new switch just like how they were before. Use your wrench to tighten the nuts snugly, but not too hard.

Harley Davidson Ignition Switch Replacement

Credit: www.harley-davidson.com

Step 7: Secure the New Switch

Place the new switch where the old one was. Line up the holes for the screws. Use your screwdriver to put the screws back in. Don’t screw them too tight! You don’t want to break anything.

Credit: m.youtube.com

Step 8: Test Your New Ignition Switch

Almost done! Put your key into the new ignition switch. Turn it just like you’re starting your motorcycle. If everything is right, you will hear your motorcycle begin to start. If not, don’t worry. Double-check your work. Maybe a wire is loose or in the wrong spot.